Specification hub
Open more sleeve applicator specification guides.
Open page →Specification guide
Neck Band Height and Perforation Specification
Tamper band height and perforation need to match the cap, neck finish and opening method.
neck band height perforationquote detailsUK supplymachine selection
Specification route
What this information is used for.
Tamper band height and perforation need to match the cap, neck finish and opening method. The clearer the detail, the easier it is to narrow the applicator, tunnel, conveyor and changeover route before price and lead time are discussed.
- cap height and neck diameter
- band grip area above and below the closure
- perforation pitch and tear direction
- opening instructions on printed bands
- required security appearance after shrink
- Confirm the information with real samples rather than brochure dimensions
- Separate must-have requirements from preferences
- Include photos or short videos of the current line where useful
- Record target output, minimum output and expected changeover frequency
Buyer tip
How to avoid over-specifying or under-specifying the line.
A sleeve applicator can often be supplied in more than one configuration. Clear project information helps avoid paying for capacity that is not needed, while also preventing a low-cost route from becoming unreliable at production speed.
Quote preparation
What to send with an enquiry.
Useful enquiry details include container samples, sleeve drawings or reel specification, desired output, available footprint, utility constraints and a short description of the upstream and downstream packaging process.
Related pages
Continue comparing sleeve applicator routes.
These pages connect this search to the machine type, application route or enquiry checklist most likely to help with selection.
Buying guide
Compare machine and tunnel selection factors.
Open page →Contact Lancing
Send details for a practical recommendation.
Open page →FAQ
Neck Band Height and Perforation Specification questions
Why does neck band height perforation matter?
Neck Band Height and Perforation Specification matters because it affects applicator selection, shrink tunnel route, output and changeover reliability.
Can I get advice before all details are final?
Yes. Early advice can still narrow the machine route, but final pricing and tooling normally need confirmed container and sleeve details.
What is the fastest way to get a useful quote?
Send container dimensions, photos, target output, sleeve format and the preferred tamper or full-body labelling result.
Project support
Send pack samples, sleeve details and target output for a practical recommendation.
Lancing can review the container, sleeve material, tunnel route, output and integration requirements before suggesting a suitable sleeve applicator configuration.
Perforation sample record
- Closure and container reference
- Band lay-flat, cut length and applied height
- Perforation type, direction and position
- Artwork orientation and opening instruction position
- Tunnel recipe and cooled finished-band condition
- Opening method, result and retained accepted sample
Opening function
Specify the perforation around the real closure opening action.
Perforation is not only an artwork feature. Its position relative to the cap, lid, thread, tear tab and user grip determines whether the band opens cleanly and leaves the intended visible evidence. The film, perforation pattern and tunnel shrink can all change tear behaviour.
Agree the opening method before the sleeve is ordered, test it after the band has cooled and repeat the check across the commercial closure range. If printed instructions are used, their orientation must remain aligned with the perforation after application and shrinking.
Specification questions
Questions about tamper-band perforation
Does a deeper perforation always make a band easier to open?
No. An aggressive perforation may split during handling or shrinking, while a weak perforation may resist normal opening. The correct result depends on film, pattern, orientation, band shrink and closure geometry and should be established by physical trials.
Can perforation position change after shrinking?
The applied band can move and the film can draw differently around the closure, so the finished position should be checked after cooling. Record both the pre-tunnel application position and the finished location.