Troubleshooting hub
Browse more sleeve applicator and shrink tunnel fault guides.
Open page →Troubleshooting
Neck Band Shrinks Unevenly Around the Cap
Use this guide when you are seeing tamper bands that look higher on one side or grip unevenly around the cap. It explains the practical checks that help separate sleeve, container, applicator and tunnel causes.
neck band uneven shrinkfault findingshrink tunnelUK support
Quick diagnosis
What this usually means on a sleeve applicator line.
This page focuses on tamper bands that look higher on one side or grip unevenly around the cap. The best fix is normally found by checking the applied sleeve before the tunnel, then checking the shrink result after the tunnel, rather than adjusting everything at once.
- Check the applied sleeve before shrink
- Check the tunnel exit result after cooling
- Keep faulty samples with the reel and container batch
- Change one setting at a time and record the result
- band is applied at an angle before shrinking
- closure or bottle neck is not concentric
- tunnel airflow or heat is biased to one side
- cap height varies across batches
Likely causes
Common causes to rule out before replacing parts.
Most sleeve faults are caused by the interaction of sleeve material, container geometry, product handling and tunnel settings. A repeatable test procedure avoids chasing the wrong cause.
Practical checks
Checks that usually narrow the fault quickly.
Use production containers and sleeves wherever possible. Empty samples, old reels and hand-applied sleeves can hide the fault that appears on the running line.
- Check applied position before the tunnel as well as after shrink
- Measure cap and neck samples from different batches
- Centre the product through the tunnel and check guide contact
- Use a narrower band or different tunnel focus if needed
When to review specification
When the issue points to machine route, tunnel route or sleeve design.
If the same fault appears after controlled setup changes, the project may need a different former size, revised sleeve layflat, altered sleeve material, improved product handling, or a tunnel better matched to the container shape. Lancing can review samples and the target output before suggesting changes.
Related pages
Continue comparing sleeve applicator routes.
These pages connect this search to the machine type, application route or enquiry checklist most likely to help with selection.
Shrink tunnels
Compare tunnel routes for heat, steam and application finish.
Open page →Quote checklist
Collect the details needed for a practical machine recommendation.
Open page →FAQ
Neck Band Shrinks Unevenly Around the Cap questions
Can Lancing help diagnose neck band uneven shrink?
Yes. Send photos, sample details and the target output. Lancing can review whether the issue is likely to be sleeve material, application setup, product handling or shrink tunnel settings.
Should the applicator or the tunnel be adjusted first?
Check the sleeve position before the tunnel first. If the sleeve is already wrong before shrinking, tunnel changes will not solve the root cause.
What samples are useful for troubleshooting?
Keep good and bad finished packs, unshrunk applied packs, sleeve reel labels and a note of machine speed, tunnel settings and container batch.
Project support
Send pack samples, sleeve details and target output for a practical recommendation.
Lancing can review the container, sleeve material, tunnel route, output and integration requirements before suggesting a suitable sleeve applicator configuration.