Troubleshooting hub
Browse more sleeve applicator and shrink tunnel fault guides.
Open page →Troubleshooting
Sleeve Reject Sensor Setup Problems
Use this guide when you are seeing good packs being rejected or bad packs passing through the line. It explains the practical checks that help separate sleeve, container, applicator and tunnel causes.
sleeve reject sensor setupfault findingshrink tunnelUK support
Quick diagnosis
What this usually means on a sleeve applicator line.
This page focuses on good packs being rejected or bad packs passing through the line. The best fix is normally found by checking the applied sleeve before the tunnel, then checking the shrink result after the tunnel, rather than adjusting everything at once.
- Check the applied sleeve before shrink
- Check the tunnel exit result after cooling
- Keep faulty samples with the reel and container batch
- Change one setting at a time and record the result
- sensor position does not see the applied sleeve consistently
- clear sleeves or reflective packs are difficult to detect
- reject timing is not matched to conveyor speed
- product spacing varies before the sensor
Likely causes
Common causes to rule out before replacing parts.
Most sleeve faults are caused by the interaction of sleeve material, container geometry, product handling and tunnel settings. A repeatable test procedure avoids chasing the wrong cause.
Practical checks
Checks that usually narrow the fault quickly.
Use production containers and sleeves wherever possible. Empty samples, old reels and hand-applied sleeves can hide the fault that appears on the running line.
- Validate detection with clear, printed and missing-sleeve samples
- Check sensor trigger point at normal line speed
- Measure distance from sensor to reject device
- Keep reject setup in the changeover record
When to review specification
When the issue points to machine route, tunnel route or sleeve design.
If the same fault appears after controlled setup changes, the project may need a different former size, revised sleeve layflat, altered sleeve material, improved product handling, or a tunnel better matched to the container shape. Lancing can review samples and the target output before suggesting changes.
Related pages
Continue comparing sleeve applicator routes.
These pages connect this search to the machine type, application route or enquiry checklist most likely to help with selection.
Shrink tunnels
Compare tunnel routes for heat, steam and application finish.
Open page →Quote checklist
Collect the details needed for a practical machine recommendation.
Open page →FAQ
Sleeve Reject Sensor Setup Problems questions
Can Lancing help diagnose sleeve reject sensor setup?
Yes. Send photos, sample details and the target output. Lancing can review whether the issue is likely to be sleeve material, application setup, product handling or shrink tunnel settings.
Should the applicator or the tunnel be adjusted first?
Check the sleeve position before the tunnel first. If the sleeve is already wrong before shrinking, tunnel changes will not solve the root cause.
What samples are useful for troubleshooting?
Keep good and bad finished packs, unshrunk applied packs, sleeve reel labels and a note of machine speed, tunnel settings and container batch.
Project support
Send pack samples, sleeve details and target output for a practical recommendation.
Lancing can review the container, sleeve material, tunnel route, output and integration requirements before suggesting a suitable sleeve applicator configuration.